Back

---

Sensitivity: A function used to consistently set the sensitivity of the signal.

<Sensitivity Display>

※To utilize Sensitivity, you must set the area where the signal sensitivity (Gain) will be increased.

※The area is set through the Gate and is based on the signals that fall within this range.

1. Ref: Enter the value that serves as the reference for the Amplitude.

2. Tolerance: Input the tolerance to specify the range (applied to the green range).

3. Clear Envelop: Resets the red line.

4. Reset: Resets the applied calibration.

5. Apply: Button to apply the calibration.

6. Finish: Button to complete or end the calibration.

   - After the calibration is complete, an S will light up at the bottom.

<Sensitivity Display>

<Sensitivity Calibration before display>

<Sensitivity Calibration after display>