top of page


 

By clicking the list in the upper right corner of the program, you can find the General icon as shown below.

The General list consists of functions that users commonly use.

  1. Depth start: Refers to the starting point of the beam, used for removing the near field and setting the inspection area.

※ (First picture: Before applying Depth start / Second picture: After applying Depth start)

  1. Depth range: A function that sets the inspection range based on the starting point of the beam.

  2. PRF: Stands for Pulse Repeat Frequency, a function used to increase the speed of inspection or to conduct more detailed inspections.

  3. Voltage: A function to set the output strength of the signal. (25~160V)

  4. Focus position: A function to set the area to be focused on when looking for defects. (Setting this makes the shape of the defect clearer.)

  5. Vector index: A function used to check the data of A-scan by each vector. When clicking the arrow, the S-scan green vector line is manipulated.

quick1.png
SEONGSANLAB(성산연구소)

ADD. Acehightechcity 13F 1318, 52, Gongdan-ro 140beon-gil, Gunpo-si, Gyeonggi-do, Republic of Korea         

Tel.  02-2039-5725         Fax.  02-2039-5726           E-mail.  admin@dspaut.com

Copyright (c)  SEONGSANLAB all rights reserved.

bottom of page