top of page


 

Encoder (Scanner): A menu for setting up the encoder to acquire image data.


The configuration menu of the encoder varies by type.


<Encoder Display>
<Encoder Display>

One Line Encoder Setting: A menu for configuring the settings when acquiring data after selecting "One Line" for the encoder.

  1. Scanner Type: There are three types: One Line, Raster, and Time.

  2. Scan Start / Stop: A menu for setting the start and end positions.

  3. Scan Step: A menu for setting the interval at which positions are acquired.

  4. Scan Resolution: A menu for entering the number of pulses generated when the encoder rotates.

  5. Clear ScanView: A function to reset the collected data image.

  6. Scan Position: A function used to change the starting position.

  7. Scan Reverse: A function used to switch to the opposite direction.

  8. Axis Swap: A function used to switch the axis.


Raster: A menu used for utilizing Two Axes.

<Encoder Raster Display>
<Encoder Raster Display>

When configuring Raster, the image data for C-scan is adjusted based on Two Axes.


While One Line is configured for One Axis, Raster is set for Two Axes, proceeding with Scan / Index settings.


Time: Short for Real Time, it is a function that helps acquire scan image data at a consistent rate based on the set speed without using an encoder.

  • When set to Time, the image is automatically collected according to the Scan Speed value.

<Encoder Time Display>
<Encoder Time Display>
  1. Speed: A menu to control the scan speed, available in three options - 1/4x1, 1/2x1, 1x.

  2. Clear ScanView: Resets the collected image and starts again from 0mm.

quick1.png
SEONGSANLAB(성산연구소)

ADD. Acehightechcity 13F 1318, 52, Gongdan-ro 140beon-gil, Gunpo-si, Gyeonggi-do, Republic of Korea         

Tel.  02-2039-5725         Fax.  02-2039-5726           E-mail.  admin@dspaut.com

Copyright (c)  SEONGSANLAB all rights reserved.

bottom of page